Ahoj,
Potřeboval bych načíst S.M.A.R.T. atributy SATA disků připojených na řadič Adaptec. Nezná někdo řešení?
Popis:
Mám řadič Adaptec 2420SA, na něm 4 SATA disky (2x Seagate ST350032 a 2x WDC WD5003ABYX0). Raid zatím není nakonfigurovaný. Operační systém je Debian Wheezy 64bit.
1. Neuspěl jsem s utilitou arcconf. Např. "arcconf GETSMARTSTATS 1 tabular" neukáže cokoliv použitelného.
2. Pomocí smartctl dostanu "SMART Health Status: OK" a to je vše:
root@track:~# smartctl -a -d scsi -T permissive /dev/sg4
smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.2.0-4-amd64] (local build)
Copyright (C) 2002-11 by Bruce Allen,
http://smartmontools.sourceforge.netVendor: ST350032
Product: 0N
Revision: SN06
User Capacity: 500,107,862,016 bytes [500 GB]
Logical block size: 512 bytes
Serial number: 9QMC7Q6F
Device type: disk
Local Time is: Tue Jan 28 11:30:41 2014 CET
Device supports SMART and is Enabled
Temperature Warning Enabled
SMART Health Status: OK
root@track:~# smartctl -a -T permissive /dev/sda
smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.2.0-4-amd64] (local build)
Copyright (C) 2002-11 by Bruce Allen,
http://smartmontools.sourceforge.netVendor: Adaptec
Product: disk1
Revision: V1.0
User Capacity: 499,950,551,040 bytes [499 GB]
Logical block size: 512 bytes
scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
>> Terminate command early due to bad response to IEC mode page
Error Counter logging not supported
scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
Device does not support Self Test logging
root@track:~# smartctl -a -d sat -T permissive /dev/sda
smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.2.0-4-amd64] (local build)
Copyright (C) 2002-11 by Bruce Allen,
http://smartmontools.sourceforge.netSmartctl: Device Read Identity Failed: scsi error unsupported scsi opcode
=== START OF INFORMATION SECTION ===
Device Model: [No Information Found]
Serial Number: [No Information Found]
Firmware Version: [No Information Found]
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: [No Information Found]
ATA Standard is: [No Information Found]
Local Time is: Wed Feb 5 09:34:11 2014 CET
SMART support is: Ambiguous - ATA IDENTIFY DEVICE words 82-83 don't show if SMART supported.
SMART support is: Ambiguous - ATA IDENTIFY DEVICE words 85-87 don't show if SMART is enabled.
A mandatory SMART command failed: exiting. To continue, add one or more '-T permissive' options.