Ahoj, potřebuji, aby mi VM guest detekoval wifi síte. Ve Windows není problém, bohužel Linux a Macos USB wifi adaptér sice rozpoznají, jenom hlásí, že WiFi Networks disconnected.
Testováno na nejnovším VirtualBoxu a též VMware Workstation.
ifconfig
wlx74da38a87730: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 74:da:38:a8:77:30 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
iwconfig
wlx74da38a87730 unassociated Nickname:"<WIFI@REALTEK>"
Mode:Managed Frequency=2.412 GHz Access Point: Not-Associated
Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
rfkill list
0: phy0: Wireless LAN
Soft blocked: no
Hard blocked: no
[ 14.383988] RTL871X: rtw_ndev_init(wlan0)
[ 14.383988] usbcore: registered new interface driver rtl8812au
[ 14.383989] RTL871X: module init ret=0
[ 14.408686] rtl8812au 1-1:1.0 wlx74da38a87730: renamed from wlan0
[ 19.708093] IPv6: ADDRCONF(NETDEV_UP): ens33: link is not ready
[ 19.712833] IPv6: ADDRCONF(NETDEV_UP): ens33: link is not ready
[ 19.715721] IPv6: ADDRCONF(NETDEV_UP): wlx74da38a87730: link is not ready
[ 25.041663] IPv6: ADDRCONF(NETDEV_UP): wlx74da38a87730: link is not ready
[ 25.183615] IPv6: ADDRCONF(NETDEV_UP): wlx74da38a87730: link is not ready
[ 25.997108] IPv6: ADDRCONF(NETDEV_UP): wlx74da38a87730: link is not ready
[ 26.138630] IPv6: ADDRCONF(NETDEV_UP): wlx74da38a87730: link is not ready