Ahoj potreboval bych poradit s konfiguraci NTP klienta. Podle tohoto
http://www.linuxexpres.cz/praxe/seridte-linuxu-hodinky clanku neni pouzivani ntpdate vhodne takze jsem si chtel nastavit ntpd, ale nedari se:( Vsechny servery mam stratum 2.
ntpq -p
remote refid st t when poll reach delay offset jitter
==============================================================================
*tik.cesnet.cz .GPS. 1 u 346 1024 1 5.706 0.305 0.32
tady je moje konfigurace NTP clienta:
# /etc/ntp.conf, configuration for ntpd; see ntp.conf(5) for help
driftfile /var/lib/ntp/ntp.drift
# Enable this if you want statistics to be logged.
#statsdir /var/log/ntpstats/
statistics loopstats peerstats clockstats
filegen loopstats file loopstats type day enable
filegen peerstats file peerstats type day enable
filegen clockstats file clockstats type day enable
# You do need to talk to an NTP server or two (or three).
#server ntp.your-provider.example
# pool.ntp.org maps to about 1000 low-stratum NTP servers. Your server will
# pick a different set every time it starts up. Please consider joining the
# pool: <http://www.pool.ntp.org/join.html>
#zakomentoval jsem ...
#server 0.debian.pool.ntp.org iburst
#server 1.debian.pool.ntp.org iburst
#server 2.debian.pool.ntp.org iburst
#server 3.debian.pool.ntp.org iburst
# Access control configuration; see /usr/share/doc/ntp-doc/html/accopt.html for
# details. The web page <http://support.ntp.org/bin/view/Support/AccessRestrictions>
# might also be helpful.
#
# Note that "restrict" applies to both servers and clients, so a configuration
# that might be intended to block requests from certain clients could also end
# up blocking replies from your own upstream servers.
# By default, exchange time with everybody, but don't allow configuration.
restrict -4 default kod notrap nomodify nopeer noquery
restrict -6 default kod notrap nomodify nopeer noquery
# Local users may interrogate the ntp server more closely.
restrict 127.0.0.1
restrict ::1
# Clients from this (example!) subnet have unlimited access, but only if
# cryptographically authenticated.
#restrict 192.168.123.0 mask 255.255.255.0 notrust
# If you want to provide time to your local subnet, change the next line.
# (Again, the address is an example only.)
#broadcast 192.168.123.255
# If you want to listen to time broadcasts on your local subnet, de-comment the
# next lines. Please do this only if you trust everybody on the network!
#disable auth
#broadcastclient
#pridane servery vsechny stratum 2
server clock1.zcu.cz # TEN, ČR
server clock2.zcu.cz # TEN, ČR
server ntp1.ctt.cz
server ntp2.ctt.cz
server ntp3.ctt.cz
V souboru /etc/ntp.conf mam na konci uvedeno
#pridane servery
ntp1.ctt.cz
ntp2.ctt.cz
ntp3.ctt.cz
clock1.zcu.cz # TEN, ČR
clock2.zcu.cz # TEN, ČR
Tzn. i prikaz ntpq -p by tento stav mel reflektovat a uvedene NTP servery by se mely zobrazit ne?
Zobrazit příspěvky
