1
Software / Re:ČT iVysílání: nefunguje stahování s yt-dlp ani youtube-dl
« kdy: 21. 03. 2023, 01:16:02 »
Z .mpd to šlo zatím vždy, což se tam i píše.
Tato sekce Vám umožňuje zobrazit všechny příspěvky tohoto uživatele. Prosím uvědomte si, že můžete vidět příspěvky pouze z oblastí Vám přístupných.
Kernel driver in use: ath11k_pci
Kernel modules: ath11k_pci
Capabilities: [50] MSI: Enable+ Count=32/32 Maskable+ 64bit-
Address: fee00818 Data: 0000
Masking: fe023c00 Pending: 00000000
pokud spustím virtualizovaný Debian, tak se změní Kernel driver z ath11k_pci na vfio-pci a hodnoty v MSI (Message Signaled Interrupts)Kernel driver in use: vfio-pci
Kernel modules: ath11k_pci
Capabilities: [50] MSI: Enable+ Count=1/32 Maskable+ 64bit-
Address: fee004f8 Data: 0000
Masking: fffffffe Pending: 00000000
Pro předání karty pomocí PCI Passthrough to bude asi správně, ale v tu chvíli se karta nenahodí ve virtualizovaném Debianu. Po vypnutí virtualizovaného Debianu, se karta ztratí i v Proxmoxu, musím jej restartovat.
qm start 108
kvm: Parameter 'max-ram-below-4g' expects size
start failed: QEMU exited with code 1
cat /etc/hostapd/hostapd.conf
interface=wlp5s0
driver=nl80211
ssid=test-prx-ax
hw_mode=a
channel=144
hostapd /etc/hostapd/hostapd.conf
Configuration file: /etc/hostapd/hostapd.conf
wlp5s0: interface state UNINITIALIZED->COUNTRY_UPDATE
Using interface wlp5s0 with hwaddr d4:1b:81:xx:xx:xx and ssid "test-prx-ax"
wlp5s0: interface state COUNTRY_UPDATE->ENABLED
wlp5s0: AP-ENABLED
iw dev
phy#1
Interface wlp5s0
ifindex 6
wdev 0x100000001
addr d4:1b:81:xx:xx:xx
ssid test-prx-ax
type AP
channel 144 (5720 MHz), width: 20 MHz (no HT), center1: 5720 MHz
txpower 20.00 dBm
O.K.
dmesg |grep ath11k_pci
[ 5.299436] ath11k_pci 0000:05:00.0: BAR 0: assigned [mem 0xf7800000-0xf79fffff 64bit]
[ 5.299462] ath11k_pci 0000:05:00.0: enabling device (0100 -> 0102)
[ 5.299679] ath11k_pci 0000:05:00.0: wcn6855 hw2.0
[ 6.265560] ath11k_pci 0000:05:00.0: chip_id 0x2 chip_family 0xb board_id 0xff soc_id 0x400c0200
[ 6.265566] ath11k_pci 0000:05:00.0: fw_version 0x110b196e fw_build_timestamp 2022-12-22 12:54 fw_build_id QC_IMAGE_VERSION_STRING=WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.23
[ 6.631636] ath11k_pci 0000:05:00.0 wlp5s0: renamed from wlan0
K.O.
dmesg |grep ath11k
[ 2.787842] ath11k_pci 0000:00:10.0: BAR 0: assigned [mem 0x100000000-0x1001fffff 64bit]
[ 2.792137] ath11k_pci 0000:00:10.0: MSI vectors: 1
[ 2.792262] ath11k_pci 0000:00:10.0: wcn6855 hw2.0
[ 2.984824] mhi mhi0: firmware: direct-loading firmware ath11k/WCN6855/hw2.0/amss.bin
[ 3.735538] ath11k_pci 0000:00:10.0: chip_id 0x2 chip_family 0xb board_id 0xff soc_id 0x400c0200
[ 3.735553] ath11k_pci 0000:00:10.0: fw_version 0x110b196e fw_build_timestamp 2022-12-22 12:54 fw_build_id WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.23
[ 3.741954] ath11k_pci 0000:00:10.0: firmware: direct-loading firmware ath11k/WCN6855/hw2.0/board-2.bin
[ 3.749997] ath11k_pci 0000:00:10.0: firmware: direct-loading firmware ath11k/WCN6855/hw2.0/board-2.bin
[ 3.774928] ath11k_pci 0000:00:10.0: firmware: direct-loading firmware ath11k/WCN6855/hw2.0/m3.bin
[ 3.819253] ath11k_pci 0000:00:10.0: leaving PCI ASPM disabled to avoid MHI M2 problems
[ 4.842675] ath11k_pci 0000:00:10.0: failed to receive control response completion, polling..
[ 5.866664] ath11k_pci 0000:00:10.0: Service connect timeout
[ 5.866693] ath11k_pci 0000:00:10.0: failed to connect to HTT: -110
[ 5.866970] ath11k_pci 0000:00:10.0: failed to start core: -110
[ 6.076262] ath11k_pci 0000:00:10.0: ignore reset dev flags 0x4000
[ 2.827244] ath11k_pci 0000:00:10.0: BAR 0: assigned [mem 0x100000000-0x1001fffff 64bit]
[ 2.832642] ath11k_pci 0000:00:10.0: MSI vectors: 1
[ 2.832871] ath11k_pci 0000:00:10.0: wcn6855 hw2.0
[ 2.853176] NET: Registered PF_QIPCRTR protocol family
[ 2.990074] random: crng init done
[ 3.010790] mhi mhi0: Requested to power ON
[ 3.010813] mhi mhi0: Power on setup success
[ 3.018213] mhi mhi0: firmware: direct-loading firmware ath11k/WCN6855/hw2.0/amss.bin
[ 3.118060] mhi mhi0: Wait for device to enter SBL or Mission mode
[ 3.766982] ath11k_pci 0000:00:10.0: chip_id 0x2 chip_family 0xb board_id 0xff soc_id 0x400c0200
[ 3.766997] ath11k_pci 0000:00:10.0: fw_version 0x110c0c35 fw_build_timestamp 2022-06-24 10:50 fw_build_id WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.16
[ 3.772905] ath11k_pci 0000:00:10.0: firmware: direct-loading firmware ath11k/WCN6855/hw2.0/board-2.bin
[ 3.780921] ath11k_pci 0000:00:10.0: firmware: direct-loading firmware ath11k/WCN6855/hw2.0/board-2.bin
[ 3.805665] ath11k_pci 0000:00:10.0: firmware: direct-loading firmware ath11k/WCN6855/hw2.0/m3.bin
[ 3.849517] ath11k_pci 0000:00:10.0: leaving PCI ASPM disabled to avoid MHI M2 problems
[ 4.878125] ath11k_pci 0000:00:10.0: failed to receive control response completion, polling..
[ 5.902094] ath11k_pci 0000:00:10.0: Service connect timeout
[ 5.902112] ath11k_pci 0000:00:10.0: failed to connect to HTT: -110
[ 5.902389] ath11k_pci 0000:00:10.0: failed to start core: -110
[ 6.111511] ath11k_pci 0000:00:10.0: ignore reset dev flags 0x4000
[ 16.142128] ath11k_pci 0000:00:10.0: failed to wait wlan mode request (mode 4): -110
[ 16.142135] ath11k_pci 0000:00:10.0: qmi failed to send wlan mode off: -110