říj 06 15:50:09 flory kernel: usb 2-1.4: new high-speed USB device number 4 using ehci-pci
říj 06 15:50:09 flory kernel: usb 2-1.4: New USB device found, idVendor=346d, idProduct=5678, bcdDevice= 2.00
říj 06 15:50:09 flory kernel: usb 2-1.4: New USB device strings: Mfr=1, Product=2, SerialNumber=3
říj 06 15:50:09 flory kernel: usb 2-1.4: Product: Flash Disk3.0
říj 06 15:50:09 flory kernel: usb 2-1.4: Manufacturer: General
říj 06 15:50:09 flory kernel: usb 2-1.4: SerialNumber: 3092861020706114934
říj 06 15:50:09 flory kernel: usb-storage 2-1.4:1.0: USB Mass Storage device detected
říj 06 15:50:09 flory kernel: scsi host7: usb-storage 2-1.4:1.0
říj 06 15:50:09 flory mtp-probe[19512]: checking bus 2, device 4: "/sys/devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.4"
říj 06 15:50:09 flory mtp-probe[19512]: bus: 2, device: 4 was not an MTP device
říj 06 15:50:09 flory systemd-udevd[19510]: 2-1.4:1.0: Process '/usr/lib/snapd/snap-device-helper bind snap_cups_cupsd /devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.4/2-1.4:1.0 0:0' failed with exit code 1.
říj 06 15:50:09 flory systemd-udevd[19510]: 2-1.4:1.0: Process '/usr/lib/snapd/snap-device-helper bind snap_cups_ippeveprinter /devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.4/2-1.4:1.0 0:0' failed with exit code 1.
říj 06 15:50:09 flory mtp-probe[19524]: checking bus 2, device 4: "/sys/devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.4"
říj 06 15:50:09 flory mtp-probe[19524]: bus: 2, device: 4 was not an MTP device
říj 06 15:50:09 flory systemd-udevd[19510]: 2-1.4: Process '/usr/lib/snapd/snap-device-helper bind snap_cups_cupsd /devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.4 189:131' failed with exit code 1.
říj 06 15:50:09 flory systemd-udevd[19510]: 2-1.4: Process '/usr/lib/snapd/snap-device-helper bind snap_cups_ippeveprinter /devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.4 189:131' failed with exit code 1.
říj 06 15:50:10 flory kernel: scsi 7:0:0:0: Direct-Access General Flash Disk3.0 2.00 PQ: 0 ANSI: 4
říj 06 15:50:10 flory kernel: sd 7:0:0:0: Attached scsi generic sg6 type 0
říj 06 15:50:10 flory kernel: sd 7:0:0:0: [sdg] 122880000 512-byte logical blocks: (62.9 GB/58.6 GiB)
říj 06 15:50:10 flory kernel: sd 7:0:0:0: [sdg] Write Protect is off
říj 06 15:50:10 flory kernel: sd 7:0:0:0: [sdg] Mode Sense: 03 00 00 00
říj 06 15:50:10 flory kernel: sd 7:0:0:0: [sdg] No Caching mode page found
říj 06 15:50:10 flory kernel: sd 7:0:0:0: [sdg] Assuming drive cache: write through
říj 06 15:50:10 flory kernel: sdg: sdg1
říj 06 15:50:10 flory kernel: sd 7:0:0:0: [sdg] Attached SCSI removable disk
říj 06 15:50:10 flory systemd-udevd[19510]: sdg: Process '/usr/bin/unshare -m /usr/bin/snap auto-import --mount=/dev/sdg' failed with exit code 1.
říj 06 15:50:10 flory systemd-udevd[19551]: sdg1: Process '/usr/bin/unshare -m /usr/bin/snap auto-import --mount=/dev/sdg1' failed with exit code 1.
$ snap list
Name Version Rev Tracking Publisher Notes
bare 1.0 5 latest/stable canonical** base
canonical-livepatch 10.7.0 246 latest/stable canonical** -
core 16-2.60.4 16202 latest/stable canonical** core
core18 20230703 2790 latest/stable canonical** base
core20 20230801 2015 latest/stable canonical** base
core22 20230801 864 latest/stable canonical** base
cups 2.4.6-4 980 latest/stable openprinting** -
gnome-3-38-2004 0+git.efb213a 143 latest/stable canonical** -
gnome-42-2204 0+git.ff35a85 141 latest/stable canonical** -
gtk-common-themes 0.1-81-g442e511 1535 latest/stable canonical** -
hunspell-dictionaries-1-7-2004 1.7-20.04+pkg-6fd6 2 latest/stable brlin -
$ cat ~/.config/xfce4/xfconf/xfce-perchannel-xml/thunar-volman.xml
<?xml version="1.0" encoding="UTF-8"?>
<channel name="thunar-volman" version="1.0">
<property name="automount-media" type="empty">
<property name="enabled" type="bool" value="true"/>
</property>
<property name="automount-drives" type="empty">
<property name="enabled" type="bool" value="true"/>
</property>
<property name="autobrowse" type="empty">
<property name="enabled" type="bool" value="true"/>
</property>
<property name="autoopen" type="empty">
<property name="enabled" type="empty"/>
</property>
</channel>
$ snap list
Název Verze Rev Následuje Vydavatel Poznámky
bare 1.0 5 latest/stable canonical\u2713 base
core20 20230801 2015 latest/stable canonical\u2713 base
snapd 2.60.3 20092 latest/stable canonical\u2713 snapd
[ 121.348179] usb 4-2: new SuperSpeed USB device number 2 using xhci_hcd
[ 121.369458] usb 4-2: New USB device found, idVendor=8564, idProduct=1000, bcdDevice=11.00
[ 121.369474] usb 4-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 121.369479] usb 4-2: Product: Mass Storage Device
[ 121.369482] usb 4-2: Manufacturer: JetFlash
[ 121.369485] usb 4-2: SerialNumber: XXXXXXXX
[ 122.070124] usb-storage 4-2:1.0: USB Mass Storage device detected
[ 122.070733] scsi host6: usb-storage 4-2:1.0
[ 122.070906] usbcore: registered new interface driver usb-storage
[ 122.076095] usbcore: registered new interface driver uas
[ 123.282659] scsi 6:0:0:0: Direct-Access JetFlash Transcend 128GB 1100 PQ: 0 ANSI: 6
[ 123.283860] sd 6:0:0:0: Attached scsi generic sg1 type 0
[ 123.284766] sd 6:0:0:0: [sdb] 236222464 512-byte logical blocks: (121 GB/113 GiB)
[ 123.285463] sd 6:0:0:0: [sdb] Write Protect is off
[ 123.285480] sd 6:0:0:0: [sdb] Mode Sense: 43 00 00 00
[ 123.286145] sd 6:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 123.299089] sdb: sdb1 sdb2 sdb3
[ 123.299481] sd 6:0:0:0: [sdb] Attached SCSI removable disk
[ 139.008510] EXT4-fs (sdb3): mounted filesystem 9a49a363-11d1-4e79-917b-6eb2bfa6b597 r/w with ordered data mode. Quota mode: none.
Oct 9 00:26:58 x301 kernel: [ 1545.342430] usb 4-1: new high-speed USB device number 6 using ehci-pci
Oct 9 00:26:58 x301 kernel: [ 1545.500955] usb 4-1: New USB device found, idVendor=8564, idProduct=1000, bcdDevice=11.00
Oct 9 00:26:58 x301 kernel: [ 1545.500978] usb 4-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Oct 9 00:26:58 x301 kernel: [ 1545.500986] usb 4-1: Product: Mass Storage Device
Oct 9 00:26:58 x301 kernel: [ 1545.500992] usb 4-1: Manufacturer: JetFlash
Oct 9 00:26:58 x301 kernel: [ 1545.500998] usb 4-1: SerialNumber: XXXXXXXX
Oct 9 00:26:58 x301 kernel: [ 1545.502108] usb-storage 4-1:1.0: USB Mass Storage device detected
Oct 9 00:26:58 x301 kernel: [ 1545.503351] scsi host4: usb-storage 4-1:1.0
Oct 9 00:26:58 x301 mtp-probe: checking bus 4, device 6: "/sys/devices/pci0000:00/0000:00:1d.7/usb4/4-1"
Oct 9 00:26:58 x301 mtp-probe: bus: 4, device: 6 was not an MTP device
Oct 9 00:26:59 x301 mtp-probe: checking bus 4, device 6: "/sys/devices/pci0000:00/0000:00:1d.7/usb4/4-1"
Oct 9 00:26:59 x301 mtp-probe: bus: 4, device: 6 was not an MTP device
Oct 9 00:26:59 x301 kernel: [ 1546.736917] scsi 4:0:0:0: Direct-Access JetFlash Transcend 128GB 1100 PQ: 0 ANSI: 6
Oct 9 00:26:59 x301 kernel: [ 1546.742863] sd 4:0:0:0: Attached scsi generic sg1 type 0
Oct 9 00:26:59 x301 kernel: [ 1546.746390] sd 4:0:0:0: [sdb] 236222464 512-byte logical blocks: (121 GB/113 GiB)
Oct 9 00:26:59 x301 kernel: [ 1546.749393] sd 4:0:0:0: [sdb] Write Protect is off
Oct 9 00:26:59 x301 kernel: [ 1546.749405] sd 4:0:0:0: [sdb] Mode Sense: 43 00 00 00
Oct 9 00:26:59 x301 kernel: [ 1546.754259] sd 4:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
Oct 9 00:26:59 x301 kernel: [ 1546.774548] sdb: sdb1 sdb2 sdb3
Oct 9 00:26:59 x301 kernel: [ 1546.775016] sd 4:0:0:0: [sdb] Attached SCSI removable disk
Oct 9 00:27:16 x301 kernel: [ 1562.958844] EXT4-fs (sdb3): mounted filesystem 9a49a363-11d1-4e79-917b-6eb2bfa6b597 with ordered data mode. Quota mode: none.
Oct 9 00:27:16 x301 udisksd[1017]: Mounted /dev/sdb3 at /media/k3dar/TR128-DATA on behalf of uid 1000
user ma skupiny:adm cdrom sudo dip plugdev lpadmin lxd sambashare
udiskctl mount -b /dev/sdd1
Ono to teda prvně nefungovalo s nějakou chybou práv. Ale pomůže smazat adresář /media/${USERNAME}. On se tam pak zase sám vytvoří a se správnými právy.Tak jde o .config/chrome-remote-desktop. Bez něj funguje, s tím nefunguje. Mám verzi 118.0.5993.9 a v minulosti to s tím fungovalo, takže asi nějaká regrese.divne, ale s tou minulosti nevim, zpetne dohledano ze problem byl (https://askubuntu.com/a/1207432/1661541) i pred 8 lety ;-)
Tak nohu do ohně bych za to nedal. USB používám málo. A to je teda vlastnost toho chrome-remote-desktop a bude už dělat pořád? Moc nechápu proč.
Ještě ten chrome-remote-desktop dělá to, že po jednom připojení už nefunguje držet lokálně klávesu a ona se sama opakuje. Což je opruz při když chcete používat kurzor v terminálu, nebo mazat víc věcí atd. To se dá nějak zvrátit?
xset r