Tak aby byla satisfakce uplna doplnil jsem ty veci, ktere se mi zatim podarilo implementovat do puvodni
knihovny na GitHubu Poslal jsem autorovi pull request, predchozi mi prijmul, tak uvidime
Jinak nakonec jsem skoncil u lusteni
datasheetu, protoze v tom navodu pro Arduino je chyba:
However there is a catch – the MSB (most significant bit, 7) in the registers above is used to determine whether that particular register plays a part in the alarm. For example, if you want your alarm to include hours and minutes, bit 7 needs to be set to 1 for the hour and minute alarm register.
No a datasheet nam rika:
By clearing the alarm enable bit (AE_x) of one or more of the alarm registers, the
corresponding alarm condition(s) are active.
Trochu nelogicky je:
1 - tento casovy udaj NEhraje roli
0 - tento casovy udaj HRAJE roli
Kdyz jsem to udelal podle datasheetu tak mi ten alarm fungoval. Tak o tom asi i pisnu tomu manikovi co delal ten navod pro to Arduino - takhle plist lidi
Diky moc za vysvetleni a navedeni spravnym smerem !